Automatic pipe cutting machine generally fails:
1. Turn on the power switch, the panel has no display and the light is on. It may damage the fuse. Please replace the fuse that meets the specifications.
2. The cutter is cut all the time. When there is no feeding, adjust the proximity switch to the proximity sensor, but it cannot touch each other. If it still does not work, it may be damaged by the proximity switch, or the computer case may be damaged.
3. Cut the length of the material:
(1) The pressure on the upper roller is not small, adjust the pressure nut and increase the pressure.
(2) The feed motor fixing screw is loose and the screw is tightened.
(3) The top roller of the lower roller is loose or the top of the feeding motor pulley is loose, and the top wire is locked.
(4) If two or more cuts are made at the same time, and the lengths of the two cuts are different, adjust the pressure on both sides of the upper roller so that the lengths of the two cuts are equal.
(5) The jitter of the feed motor feeding, rather than the smooth movement, is to drive the box failure, please replace the good drive box.
4, press the start machine no action:
(1) If the pre-cut length and pre-cut quantity are set to 0, the machine will not operate. Please set the correct value.
(2) The pre-cut quantity is the same as the cut quantity, please press the zero key to return to 0.
(3) If the above methods are invalid, the computer box is faulty.
5, when using cutting, the belt can not be cut;
(1) Whether the blade is notched or blunt, please grind or change the knife.
(2) Partially broken, part of the continuous, please put a piece of paper on the back of the knife under constant pressure.
(3) Adjust the blade clearance screw, first loosen the nut, then screw the screw in, then fix the nut, please pay attention! When the screw is turned to the end, it is possible to top the gap plate and directly affect the up and down movement of the carriage.
