Everyone knows that after a period of use, the internal parts of the pipe cutting machine will wear to a certain extent. If not maintained in time, the service life of the equipment will be reduced, and the work process will be affected during the work. But if it is usually well protected, it will reduce this phenomenon.
Reasons for wear caused by the pipe cutter:
First, in our practical application, many people who operate the pipe cutting machine do not understand the operation procedures of the machine and the performance of the machine. It is likely to be mishandled during use, resulting in damage to the pipe cutting machine.
Second, we must clearly know what the maximum load of our mechanical equipment is, so as to prevent the mechanical damage caused by excessive load during use.
Third, the load of the pipe cutter must be uniformly accelerated, so that the machine is under a relatively stable load to change.
Fourth, the cause of the wear of the pipe cutting machine is because the protective work is not done, so that the oil leakage of the bending hoop parts runs, which has a huge impact on the original operating environment, resulting in increased wear and tear during operation, and the operating frequency of the parts is increasing. Under the influence of various factors, the operation failure occurs.
Daily maintenance of the pipe cutter:
1. Before starting the machine, carefully check whether the parts of the machine are normal and whether the connecting bolts are securely fastened. Is there a leak in the trachea? The fastening bolts of each part should be checked regularly with a wrench for looseness.
2. The parts that need lubrication must be filled with lubricating oil at regular intervals.
3. Replace the cutter or overhaul the machine, please cut off the power supply and hang up the maintenance card.
4. Clean up the machinery and sanitation in time to keep the equipment clean.
5. Turn off the power and turn off the air supply after work.
