The pipe cutting machine plays an important role in the machinery industry. Because it belongs to the cutting machine, it also makes it more dangerous than the general machinery, so we are using the pipe cutting machine. Time needs to be taken seriously and strengthened. With the advancement of society, automation equipment has been replaced in various factories, but occasionally accidents have occurred. Therefore, the following points have been compiled to ensure the safety of operators.
1. Wear personal protective equipment properly. . It is stipulated that it must be worn when worn, and must not be worn if it cannot be worn. For example, when cutting a pipe, the female worker is required to wear a protective cap, and if it is not worn, the hair may be twisted. At the same time, it is required not to wear gloves. If it is worn, the rotating part of the pipe cutting machine may twist the gloves in, which will easily cause the hand to be wounded.
2. Before the operation, the safety inspection of the pipe-cutting mechanical equipment should be carried out. First, the empty car should be operated and confirmed to be normal before it can be put into operation.
3. During the operation of the pipe cutting machine, the safety inspection should also be carried out according to the regulations. Especially for fastened items, check for looseness due to vibration and retighten in time.
4. When the equipment is faulty, it must not be used to prevent accidents.
5. When the pipe cutting machine is running, it is strictly forbidden to adjust by hand, nor can it measure parts by hand, or lubricate or clean debris. If necessary, turn off the machine immediately.
6. The tools, fixtures and machined parts used in the pipe cutting machine must be securely installed and must not be loose.
7. The mechanical safety device must be used correctly according to the regulations, and it must not be removed and not used.
8. When the pipe cutting machine is working, the operator must not leave the job to prevent the problem from being disposed of.
9. After the work is finished, the switch should be closed, the tool and the workpiece should be taken out from the working position, and the working site should be cleaned up, the parts and fixtures should be placed neatly, and the cutting machine equipment should be cleaned.
