Stainless steel pipe cutting machine manufacturers give you a brief introduction to the installation instructions of the pipe cutting machine:
1. After pushing the pusher to the installation position, gently lower it, do not fall or collide.
2. Use the spirit level to adjust the machine to a horizontal position.
3. Be sure to connect the green bottom line to avoid danger of leakage.
4. Connect the power cord, please connect the fuseless switch or the knife switch. Be careful not to have a phase loss, so as to avoid the motor burning due to the inability to start. After starting the motor, check whether the running direction is the same as the red arrow on the blade cover. If the rotation axis is reversed, replace the two of the power cables. Note that the green ground wire cannot be exchanged.
5. Be careful not to change the speed during sawing. If you need to change the speed, turn off the spindle first, and then change the speed after the spindle is completely stopped, so as to avoid damage caused by abnormal operation of the motor or spindle head gear.
6. When installing the saw blade, refer to the red arrow on the saw blade cover. Do not reverse the saw blade to avoid the danger of the saw blade breaking. Lock the saw blade to lock the bolt in the opposite direction of the red arrow to ensure that the saw blade is locked and will not be loose before starting the spindle. The loose saw blade will cause maintenance and maintenance damage during sawing.
